Baofeng Uv 5r Programming Software Windows 8

The BAO-5R software helps you program memory channels and menu settings of many Baofeng UV-5R radios variations.Works with UV-5, UV-5R, UV-5R+, UV-5RA, UV-5RC, UV-5RE, UV-5RV2+. UV-5RTP, UV-5RI6+, UV-5RCx (2M/220MHz),UV-5X, UV-5XP, UV-5R3 and the new UV-5R3band, UV-5RX3 and UV-5R IIIradios for all firmware versions as of (these change continually and must be addressed on a per case bases if problems arise.) See the list below in red for model exceptions for this programmer.The BAO-5R Radio Programmer is available for either Windows OS or Mac OS. Operating System selection available when adding to cart.Software will NOT work with the, the Baofeng,radios.Note: An exception is the UV-5Rx3 radio being sold by Main Trading from Paris Texas. This IS the right software for those.

• Baofeng Uv 5r Programming Software Windows 8 Download

Since the UV-5R series share the same manufacture programming software and CHIRP support most of Baofeng UV-5R models, this programming guidance is a helpful preference to the following model：Baofeng GT-3, BF-F8/BF-F8+, BF-F9, UV-5R+/UV-5R+Plus, UV-5RA/UV-5RA+/UV-5RAX+, UV-5RAX (2M/1.25M), UV-5RE/UV-5RE Plus, etc.Use to 25% promotion code / promo code → Baofeng25← to get a!, limited 50 of total usePreparation before Programming1. Computer System RequirementsOperating System: Windows 98, Windows Me. Windows XP, Windows 7, Windows 8 and Windows 10Hard Disk Space: at least 50MB availableMinimum memory: 64M2. Programming CableA. The driver should be installed before programming.1) Find the corresponding driver of the system.2) Click install and wait for the installation.B.

Baofeng Uv 5r Programming Software Windows 8 Download

If you use an, it does not need to be installed with a driver. You can just plug in and use directly.3. Software Download & Install1) Turn on the computer, check if your computer system meets the requirements.2) Download the on radioddity.com or.3) Install the programming software.4. Connect your Walkie Talkie with Computer1) USB programming cable connects with the computer end.2) Connect the other end of the cable with your walkie talkie.3) When both ends have been connected, turn on your radio.